Until recently, sheet metal was opened by a laborious and low-precision processing process. The situation has changed for the introduction of advanced technologies for cutting metal behind the addition of laser production.
The process of laser opening of metal to the polarity is in the fact that the laser is concentrated in the singing point of the surface of the material, that is, for the processing, heating it to the required temperature, so that the material is not needed to be opened. Oversupplying promin, it is possible to give the line the necessary vigin and to read the details of the new form - from the simple to the supervisors themselves.
Laser cutting sheet metal can be easy to cut: the accuracy of cutting (allowing the accuracy of 10 microns and more); the edge along the line does not cause scuffing or tearing, nor does it damage the pre-finished mechanical treatment in front of the scratching; allowing to carry out the opening of aluminum, medium, stainless steel, using the other methods of folding; the ability to reject any contour; the highest productivity, little term for vikonannya replacement; the visibility of the mechanical injection on the metal, which allows a significant economy of expensive metal.
All tsі perevagy allow vikoristovuvat laser cutting of sheet metal for vіkonannya great spectrum of production. Until then, laser engraving on metal is possible, if the laser does not pierce the sheet, but deprives it of a small surface area.
