The cylindrical gearbox Ts2-1000-8 is a two-stage mechanism that implements a planetary gear. Equipment of this type is used in the work of lifting equipment - cranes, including. You can get acquainted with the detailed characteristics of the gearbox of this model on the website https://reductory.ru/reduktor/kranovye-c2/reduktor-c2-1000.
Key benefits of the mechanism
Model Ts2-1000-8 is in great demand in the fields of mechanical engineering, construction, and industry. The unit has managed to establish itself in the market due to a number of important qualities:
-
Ts2-1000-8 reducer is characterized by significant efficiency. The efficiency of the device often reaches 90-94%, which allows for an economical consumption of energy resources.
-
The model provides high power indicators, demonstrates itself well in operation under heavy loads.
-
The output shaft of the unit has a minimum backlash, which provides the highest kinematic accuracy.
-
If necessary (for example, in the event of a sudden power outage), the shaft can be rotated manually.
-
The operating temperature of the reducer is not high. Almost all energy is converted into power, which affects the performance of the mechanism.
-
Even with a short increase or decrease in load, the model will remain stable.
You can buy this gearbox model directly on the website https://reductory.ru/reduktor/kranovye-c2 /reduktor-c2-1000 . The Reduktor company supplies equipment of its own production in Moscow and St. Petersburg, as well as throughout the Russian Federation. The presented model of a gearbox with a gear ratio of "8" has the following qualities:
- handles varying loads with ease;
- features the ability to rotate the shafts in both directions: forward and reverse;
- is intended for use in cranes, winches, and other types of lifting machines.
Operational Features
In order to ensure the correct operation of the gearbox, it is important to responsibly comply with the main requirements for its operation. Use oils of good quality (filled before using the equipment at the time of the first start-up), make sure that the shafts remain parallel and aligned. The equipment is not recommended for use in conditions of high dust content - it should not exceed the parameter of 10 mg per cubic meter in the area of operation of the lifting equipment. meter.
Overload in progress
