In any country, construction work is constantly and quite actively carried out. Of course, this is the reason that the demand for rolled metal products is very high. Despite the fact that many alternative materials have appeared on the market, metal continues to occupy a leading position, and is considered an indispensable component of most constructed structures and structures. And Mayakovskaya metro hotels are no exception. Technical parameters of the structure are highly dependent on the correct selection of rolled metal, as well as on how high-quality and reliable metal was chosen.
Possessing excellent properties, rolled metal makes it possible to build commercial, industrial and production facilities. In engineering roofs and structures, the main and important part is metal. For the construction of a conventional residential building, the entire range of products in this area is required. In the foundation of the publication, construction reinforcement is used, channels and beams in the bearing walls, and for the creation of engineering networks - metal pipes , mesh for reinforcement and floor pouring. All hostels of the Revolution Square metro station or any other metro station are built using wire and sheet metal. Boxes and corners are used to create various metal structures.
Today, in modern construction, you can find a variety of types of rolled metal. It can be section rolled metal , which includes reinforcement, beams, strips, square, circle, rails, hexagons and other section metal rolling. Shaped type includes corner, channel and corner, sheet type - cold and hot rolled sheet, galvanized sheets, corrugated board, as well as other rolled products.
Rebar can almost always be found in the composition of reinforced concrete structures. It is used for reinforcement. It is produced on the basis of the GOST standard. There are several types of fittings: smooth and periodic. Low-alloy carbon steel is used for the production of this rolled metal, 6-12 meters long.
The beam is the material used for the construction of floors in the construction of houses. It can be I-beam or metal. The latter are divided depending on how thick the ceiling and walls are. The location of the edges determines how these beams will relate to each other when laid: sloped or parallel.
