Many owners are faced with a situation where the liebherr refrigerator suddenly stops cooling normally, and the called master issues an account that seems unreasonably high. For example, a typical situation - replacing a temperature sensor, an origine sensor costs about 1,500 rubles, can turn into repair costs from 7,500 to 15,000 rubles. If repair of liebherr refrigerators at home is performed by the service center, then the cost of the departure of the master in Moscow, the diagnosis and urgency of the call are not taken into account. But the owners of technology often ask themselves: do I overpay?
versed in the issue of the cost and expediency of repair, it is important to consider several factors.
You must also understand that the repair of one part does not guarantee the absence of problems in the future. For example, replacing a sensor temperature sensor can solve the problem temporarily, but after a few months other components can fail.
In the liebherr refrigerator, the temperature was lost - the causes of the malfunction
Often, the refrigerator malfunction is manifested in the fact that the temperature inside does not correspond to the given: for example, in the freezer is too warm, and in the refrigerator - on the contrary, it is too cold or vice versa. First of all, you should reset temperature settings for factory and make sure if the problem is repeated. If the problem is saved, you can try to diagnose yourself.
Integles the ice on the evaporator
One of the causes of poor cooling can be the excessive icing of the evaporator (a serpentine located behind the rear wall of the freezer). Excessive ice formation occurs with a malfunction of the automatic defrosting system - No Frost. This can happen due to the failure of the temperature sensor of the evaporator or damage to the seals of the refrigerator door.
independent check is simple: it is enough to completely defrost the refrigerator, turning it off the network and leaving the doors open for 24–48 hours. If, after complete thawing, the refrigerator begins to cool normally, this means that the problem is in the automatic defrost system. It will take a replacement of the corresponding component.