Diamond cutting is an excellent modern method that allows you to cut openings in walls and materials of various origins (monolith, brick, reinforced concrete). The peculiarity of this method lies in the elimination of vibration, which has a destructive effect on the walls. You will also be pleasantly delighted with how flat and smooth the surface will be. At the same time, the noise is minimal, and the accuracy is maximum. Combining all these qualities together, it is safe to say that diamond cutting is a new word in wall cutting.
The working tool is a diamond cutting blade . Accordingly, it is difficult to overestimate the importance of choosing the right disc for you. These are what they are:
- Discs for working with non-abrasive materials (clinker, marble) have a docile bonding agent. Scope of application - seam cutters , wall saws.
- Disc for working with hard metals (granite, reinforced concrete) have a medium to soft bond strength.
- Discs for working with soft abrasive materials (silicate, chamotte, asphalt) have a hard binder. Scope of application - stone cutting machines , seam cutters, wall saws.
The cuts are also either wet or dry . In principle, with a dry cutting disc, it is possible to carry out wet cutting too, but you should not lose sight of the fact that the disc wear will be greater, and the work process itself will take longer. But in the opposite direction, the scheme will not work. Indeed, during wet cutting, the blade is cooled with water, and depriving it of this cooling, you risk breaking the installation.
Diamond cutting with the wrong grade
If an excessively hard binder is used, there is a chance for the cutting edge to get stuck. This can also happen with excessive pressure on the tool. To identify these unwanted moments, pay attention to the segment. If it is highly polished, and the work is carried out at a decreasing speed, then the process must be stopped immediately. To return the disc to its previous qualities, it is recommended to cut the abrasive material, or resort to a sharpener until tuberosity appears. In cases of relapse, it is recommended to change the brand to a softer one.
Efficient diamond cutting is not possible and the blade becomes unusable ...
If the grade does not match the material, a situation of rapid wear of the disc arises. Such problems arise when using a disc with a soft composition. You will be able to see how the cutting part is erased. In this case, you need to change the disc.
