A drill for a perforator is a tool that is cast from metal, while it is used exclusively for drilling products from natural or artificial stone and, of course, concrete. You can use a similar tool in construction and repair activities. It has its own classification parameters:
• Geometric shape of the spiral part;
• Tool design;
• The power of the equipment with which the drill will be used;
• Shank type.
Using drills
The SDS Plus drill manufactured by Insel . According to information from specialists, this device is used exclusively in small and medium power rock drills. For domestic purposes, perforators weighing up to 5 kilograms are usually used. SDS-Plus concrete drills are purchased as nozzles for them, in which the tail radius does not exceed 0.9 cm.
It goes without saying that without drilling in various surfaces, neither construction nor repairs are possible. In particular, concrete is considered one of the most complex structures, which only a hammer drill can handle.
Selecting a punch bit
Not the easiest moment - this is the choice of a drill for a hammer drill. To choose it correctly, you need to know the following characteristics:
• Length, because from this size the depth of a possible hole;
• Diameter.
The design of the drill has a powerful design, the main part of which is made in the form of a double helix, which indicates that they have a rather long operating time without sacrificing performance.
Reasons for breakage of drills
Most often, SDS-plus concrete drills are produced by Chinese companies. Naturally, they meet all the requirements according to GOST, so they can be purchased on the website www.insel.kiev .ua and install without fear. However, it should be noted that the drill cannot be installed on a regular drill, even with great efforts.
SDS + concrete drills are consumables that cannot be repaired. But at the same time it is not disposable and with the correct, uniform load it can work for a long time.
With regard to breakdowns, most often they are caused by such cases as frequent overload and excessive load. It is also worth noting that if the operating mode is incorrect or if it hits the armature, the liner may break, so you need to be extremely careful when determining the load on each individual drill.
